2001 Arctic Cat ATVs factory service and repair manual, Page 341Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 341

Fig6-141 Fig6-143 6Inspect the splines of the shaft, the bearing ring, and the housing for damageNOTE: If any damage is apparent
onto the shaft with the new clamps positioned as shownNote the different-sized clamps from removalNOTE: The boot is positioned
correctly when the small end of the boot seats down into the recessed groove NOTE: At this point if the outer boot is damaged,
continue with step 8 8Loosen both outer boot clamps and slide the outer boot off the shaftNote the position of the different-sized