2001 Arctic Cat ATVs factory service and repair manual, Page 343Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 343

Fig6-150 Fig6-153 Fig6-151 8Inspect the axle components for correct positioning of the four clampsAlso, inspect the boots
the bearing ring; then install the circlipFig6-152 1Place the ATV on support stand (positioned just in front of and behind
the footrest on each side) so the wheels are off the floor ! WARNING Make sure the ATV is solidly supported on the support
stand to avoid injury 2Remove the rear wheels3Remove the cap screws securing the hydraulic brake caliper(s) to the bearing