2001 Arctic Cat ATVs factory service and repair manual, Page 346Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 346

+ Click Here Back ASSEMBLING Fig6-167 1Grease the splines of the axle housingFig6-165 4Lightly grease the bearing housing
5Place the axle gasket on the axle housingRotate the axle shaft slightly to ensure proper engagement with the gear case splines6Rotate
the bearing housing until the brake caliper mounting holes are on the top side; then secure the bearing housingaxle assembly
to the axle housing with four cap screwsTighten to 5.5 kg-m (40 ft-lb)Fig6-169 3Secure the axle housinghitch to the rear
drive housing with four cap screwsTighten to 4.8 kg-m (35 ft-lb)NOTE: If new rear drive housing is being installed, tighten