2001 Arctic Cat ATVs factory service and repair manual, Page 347Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 347

INSTALLING Fig6-172 1Maneuver the axle assembly forward making sure propeller shaft splines engage properly and the final
using the cap screws and hex nuts tightened to 4.8 kg-m (35 ft-lb)Fig6-171 5Place the gear case panel into position and secure
with the three cap screwsTighten the two side cap screws to 0.7 kg-m (5 ft-lb) and the bottom cap screw to 1.1 kg-m (8 ft-lb)Fig6-173
Fig6-174 ! CAUTION Do not tighten nuts beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet or mount WILL be