2001 Arctic Cat ATVs factory service and repair manual, Page 350Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 350

2Drain the brake fluid from the entire hydraulic system (master cylinder, hoses, and caliper)Fig6-184 ASSEMBLINGINSTALLING
3Remove the brake hose from the caliper; then remove the caliperFig6-185 3Place the brake caliper assembly into position
and secure with the cap screws tightened to 2.8 kg-m (20 ft-lb)4Place new flat washer on each side of the brake hose fitting
and install it on the caliperTighten to 4.2 kg-m (30 ft-lb)5Fill the master cylinder; then bleed the brake system (see Section
2)6Install the wheelTighten to 6.9 kg-m (50 ft-lb)AF636D Fig6-187 CLEANING AND INSPECTING 1Clean all caliper components (except