2001 Arctic Cat ATVs factory service and repair manual, Page 358Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 358

Swing Arms (400500 cc) REMOVING 1Remove the cap screws and lock nuts securing the front of the swing arms to the frame brackets2On
the retainer2Place bushings and sleeves (where appropriate) into shock eyelet; then install shock with two cap screws and
nutsTighten all nuts to 4.8 kg-m (35 ft-lb) 3On the right side, remove the cap screw and lock nut securing the outer swing
arm to the axle housing; then remove the cap screw and lock nut securing the inner swing arm to the axle housingRemove the
hose grommets from the hose guides4Remove the swing arms and note the location of the hose guides on the inner swing arm
(for assembly)CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement
is necessary ! CAUTION Do not tighten the nuts beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet or mount