2001 Arctic Cat ATVs factory service and repair manual, Page 359Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 359

INSTALLING 1On the right side, place the inner swing arm into position and secure it to the axle housing with cap screw and
with cap screws and hex nuts; then tighten all fasteners to 4.8 kg-m (35 ft-lb)AF701D 4Remove the brake caliperFig7-12 REMOVING
1Secure the ATV on support stand to elevate the wheel; then remove the wheel ! WARNING Make sure the ATV is solidly supported
on the support stand to avoid injuryAF615D 2Remove the wheel cap from the hub; then remove the cotter pin from the nutFig7-10
5Remove the hub assembly6Remove the cotter pin and slotted nut securing the tie rod end to the knuckle; then remove the tie