2001 Arctic Cat ATVs factory service and repair manual, Page 371Get this manual

Handlebar Grip REMOVING 1Remove the plug from the head of the rivet2Using 18-indrill bit, drill out the rivet3Using compressed
1Apply liberal amount of Handlebar Grip Adhesive (pn 0636-071) to the inside of the gripAF778D 8Place the gas tank into positionSecure
with screws and washersFig8-20 2Align the rivet hole in the grip with the rivet hole in the handlebar; then align the notch
(inside the grip) with the slot in the handlbar and slide the grip onto the handlebar until it is fully seated3Wipe off any
excess glue; then secure the grip with new rivet4Install the plug on the head of the rivet Knuckles REMOVING AND DISASSEMBLING
9Connect the fuel hose to the carburetor10Install the left-side panel; then install the seatNOTE: Turn the gas tank valve
to the ON position only if starting the engine 1Secure the ATV on support stand to elevate the wheel; then remove the wheel