2001 Arctic Cat ATVs factory service and repair manual, Page 386Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 386

CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
and self-tapping screwsINSTALLING 1Place the flare or extension into positionUsing the Plastic Rivet Setter (pn 0444-056),
secure with Plastic Rivets (pn 0423-046) or suitable substituteNOTE: If installing front extension, secure to the side panel
with the self-tapping screw and clipAF602DA 2Tighten the machine screws securely3On the 250300 cc models, secure the deflector
panels with plastic rivets4Install the front rack (see Front Rack in this section) 2Secure the extensions or flares with
the screws, T-nuts, and concave washersNOTE: The rear extensions are secured with clips and self-tapping screws Belly Panel
REMOVING 1Remove the machine screws and shoulder washers securing the belly panel to the underside of the frame2Remove the