2001 Arctic Cat ATVs factory service and repair manual, Page 388Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 388

Rear Fender REMOVING Adjusting Headlight The headlights can be adjusted vertically and horizontallyThe geometric center of
on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most
intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the aiming surfaceFig8-74 5Disconnect
the taillight wiring harness three-prong connector; then remove the fenderCLEANING AND INSPECTING NOTE: Whenever part is
worn excessively, cracked, or damaged in any way, replacement is necessary 1C ea ll re ar fender components with parts-cleaning
solvent and soap and water2Inspect side panels, fender extensions, and rear fenders for cracks and loose rivets3Inspect threaded
areas of all mounting bosses for stripping4Inspect for missing decalsINSTALLING 1Place the rear fender into position on the
frame; then install the cap screws and washers (with battery hold-down bracket on the 400500 cc models)2Tighten the cap screws
to 5.5 kg-m (40 ft-lb)3Route the taillight wiring harness over the rear frame; then connect the three-prong connector4Install