2001 Arctic Cat ATVs factory service and repair manual, Page 389Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 389

! WARNING Do not operate the ATV unless the headlight beam is adjusted properlyAn incorrectly adjusted beam will not provide
harness, three-prong connector, lens, base, cap screws, and socket for damage2Inspect all wires for corroding, pinching,
and cracking3Inspect the bulb for wattage, voltage, and proper operationINSTALLING 1Place the assembly into position on the
frame and secure with torx-head cap screws and any washers2Tighten the cap screws securely0732-336 3Route the wiring harness
over the rear frame; then connect the three-prong connector REMOVING 1Unplug the three-prong connector and free the taillight