2001 Arctic Cat ATVs factory service and repair manual, Page 401Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 401

AF715DA 4Remove the E-ring and pin securing the reverse cable to the reverse actuator arm; then loosen the jam nut securing
cable through the appropriate wire forms and secure with cable ties 3Place each end of the reverse cable into the frame mounts
and secure with the jam nuts4Insert the upper end of the reverse cable into the hole in the reverse lever and secure with
an E-ringFig9-32 1Slide the reverse shift axle into the reverse shift leverWith an O-ring on the reverse shift axle, secure
the reverse lever to the reverse lever bracket with the reverse shift axleFig9-30 AF714DA 5Install the reverse lever over-center