2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 28Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 28

KEY 12345678910111213141516171819202122Engine Oil Pump Driven Gear Pin Circlip 16 Cap Screw Strainer Cap Screw Cap O-Ring
install the filler plug CAUTION Any oil used in place of the recommended oil could cause serious engine damageDo not use
oils which contain graphite or molybdenum additivesThese oils can adversely affect clutch operationAlso, not recommended
are racing, vegetable, non-detergent, and castor-based oils CC442DA 9Start the engine (while the ATV is outside on level
ground) and allow it to idle for few minutes10Tum the engine off and wait approximately one minuteRecheck the oil level in
the engine oil inspection windowThe oil level should be visible through the windowIf oil is not visible, add recommended
oil until the oil level is visible between the lines of the window 3Remove the Phillips-head screws securing the strainer;
then remove the strainer NOTE: To service the oil strainer, see Section 3 4Place the oil strainer into position and secure