2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 35Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 35

TAILLIGHT-BRAKELIGHT !o replace the taillight-brakelight bulb, use the followmg procedure1Remove the two screws and remove
should be an average operating load on the ATV when adjusting the headlight aim Svvitches Each time the TV is used, switches
should be checked for proper operationUse the following list for referenceAIgnition switchengine will startBEmergency stop
switchengine will stopeReverse switchreverse indicator light illuminatesDHilLo switchheadlight beam bright and dimEBrake
switchesrear brake light illuminates 2Measure the distance from the floor to the mid-point of each headlight3Usi!lg the measurements
obtained in step 2, make honzontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks on
the aiming surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe
each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal