2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 39Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 39

ARemove the cover and fill the master cylinder with DOT Hi-Temp Brake Fluid (pin 1639-799)BInstall and secure the cover;
procedure, and maintenance of the hydraulic brake systemINSPECTING HOSES Carefully inspect the hydraulic brake hoses for
cracks or other damageIf found, the brake hoses must be replacedCHECKINGREPLACING PADS Brake DiscBleeder Screw The clearance
between the brake pads and brake discs is adjusted automatically as the brake pads wearThe only maintenance that is required
is replacement of the brake pads when they show excessive wearCheck the thickness of each of the brake pads as follows1Remove
front wheel2Measure the thickness of each brake padHyd ra uIic Brake Caliper 730-434B NOTE: During the bleeding procedure,
watch the master cylinder reservoir very closely to make sure there is always sufficient amount of brake fluidIf the fluid
level gets below the bottom line on the reservoir, refill the reservoir before the bleeding procedure is continued DRepeat
step until the brake lever is firmEAt this point, perform step B, C, and on the other FRONT bleeder screw; then move to the