2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 40Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 40

Brake Pedal ATV0088D CInstall the new brake pads; then secure with the pin and cotter pinSpread the cotter pin 2If the rear
5.5 kg-m (40 ft-Ib)5Burnish the brake pads (see Burnishing Brake Pads in this section) Auxiliary Brake adjuster arm to the
rightCHECKING 733-7308 2Pull the brake cable to the left and push the 3While holding the cable and adjuster arm in this Although
the auxiliary brake has been adjusted at the factory, the brake should be checked for proper operationThe brake must be maintained
to be fully functional1With the engine off, transmission in neutral, and the reverse lever in the forward position, press
the brake pedal and attempt to move the TV position, finger-tighten the left-hand jam nut until it contacts the adjuster