2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 42Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 42

3Repeat procedure on each brake system five times until brake pads are burnished4Adjust the auxiliary brake (if necessary)5Verify
to the bottom of the stand pipe in the radiator neck 3Remove the cap screws securing the cooling shroud to the -belt cover;
then remove the cooling shroud 4Remove the cap screws securing the V-belt cover noting the location of the different-lengthed
cap screws for installing purposes; then using rubber mallet, gently tap on the cover tabs to loosen the coverRemove the
cover NOTE: Note the location of the main engine ground wire for installing purposes CAUTION After operating the ATV for
the initial 5-10 minutes, stop the engine, allow the engine to cool down, and check the coolant levelAdd coolant as necessary