2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 43Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 43

2Place the -belt into position on the driven clutch and over the front shaft 6Remove the -belt NOTE: The arrow on the V-belt
by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are separated, insert
wedge (approximately 38 inthick) between the facesRelease the inner face NOTE: At this point, the wedge can be removed from
between the driven clutch faces 4Rotate the -belt and clutches until the -belt is flush with the top of the driven clutch