2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 63Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 63

Removing Right-Side Components ACover 1Tum the gas tank valve to the OFF position and 2Slide the clutch release arm and gear
pins 3Remove the release roller assemblyAccount for four springs4Remove the starter clutch-shoe nut (left-hand threads) and
washer from the driveshaft; then using clutch shoe remover, remove the clutch shoe CAUTION Care must be taken when removing
the nut; it has "left-hand" threads NOTE: It will be necessary to remove the lower rear oil filter cover stud and the upper
arm cap screws to provide clearance for removing the cover Release Roller Assembly Starter Clutch Shoe Starter Clutch Housing