2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 66Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 66

Separating Crankcase Halves 1Remove the two cap screws securing the starter to the crankcase; then remove the starterAccount
washer from the reverse shifting cam NOTE: To keep the shaftgear assemblies intact for identification, tap the shafts toward
the right-side crankcase half when separating the halves AT THIS POINT To service center crankcase components only, proceed
to Separating Crankcase Halves Center Crankcase Components NOTE: This procedure cannot be done with the enginetransmission
in the frameComplete Removing procedures for Top-Side, Left-Side, and Right-Side must precede this procedure NOTE: For efficiency,