2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 81Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 81

2Inspect the spnngs and ratchet for wear or damage3Inspect the reel and case for cracks or damage4Inspect the shaft for wear,
spring must seat evenly in the recoil case 6Install the ratchet onto its pin making sure the end is properly installed on
the reel 7Install the shaft, spring, and the spring cover 2Insert the rope through the hole in the reel and tie knot in the
end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply
low-temperature grease to the spring and hub4Thread the end of the rope through the guide hole of the case; then thread the