2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 82Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 82

MEASURING SHIFT FORK (Thickness) NOTE: Whenever shift fork is out of tolerance, replacement is necessary 1Using calipers,
and allow the rope to retract12Pull the rope out two or three times to check for correct tension NOTE: Increasing the rotations
in step 11 will increase spring tension Reverse MEASURING SHIFT FORK GROOVE 1Using calipers, in tum measure the width of
each shift fork groove 13Place the gasket and recoil starter assembly into position on the left-side cover noting the location
of the single washer; then tighten the cap screws to 0.8 kg-m (6 ft-Ib) 2Shift fork groove width must be within the specified