2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 98Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 98

NOTE: The countershaft is now completely assembled for installation Assembling Crankcase Half NOTE: For ease of assembly,
into the crankcase 5Press the 2nd drive gear onto the countershaft leaving an 0.25 mm (0.010 in gap between the 2nd and 5th
drive gears NOTE: When pressing the 2nd drive gear onto the countershaft, the inside of the gear must be oil free; then apply
thin, even coat of green Loctite #620 being careful not to get Loctite on the other gears CAUTION 4Install the reverse idle
shaft; then install washer, bushing, reverse idle gear, and spacer Pressing the 2nd drive gear off may be done twice before