2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 102Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 102

5In crisscrosscase-to-case pattern, tighten the mm cap screws until the halves are correctly joined; then tighten to 2-2.4
the oil strainer into posItIOn beneath the crankcase and tighten with the Phillips-head cap screws (coated with red Loctite
#271) securely After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side
Components, and to Installing Top-Side Components & CAUTION The legs of the strainer must be directed out Installing Right-Side
Components AOil StrainerOil Pump BGear Shifting Arm NOTE: If the oil pump was serviced, follow steps 1-2 1Place the oil pump
into position on the crankcase and secure with the Phillips-head screws coated with blue Loctite #243Tighten to kg-m (7 ft-Ib)