2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 109Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 109

CStator AssemblyCover DStarter Cup ERecoil Starter NOTE: Steps 1-16 in the preceding sub-section must precede this procedure
the crankcase making sure the alignment pins are in place19Install the cap screws to secure the left-side cover noting the
location of the different-sized cap screws; then only finger-tighten at this time20Place the starter cup into posItIOn on
the crankshaft making sure new, lubricated O-ring is inside the cupTighten the nut with lock washer to 3.5 kg-m (25 ft-lb)
Installing Top-Side Components APiston BCylinder 21Tighten the left-side cover caps screws (from step 19) to 0.9-1.3 kg-m