2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 120Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 120

Table of Contents (400Manual Transmission) 2Remove the negative cable from the battery; then remove the positive cableRemove
3Near the battery tray, remove the two screws securing the fuse block; then carefully remove all the wiring from the block
CAUTION It is critical that all wiring be marked when removing from the fuse blockThis will aid in installing correctly 4Carefully
guide the battery cables and fuse block wiring down through the access hole into the engine compartment for future removing5Drain
the oil transmissionEngine! Transmission beneath Removing Enginel Transmission Many service procedures can be performed without
removing the engineltransmission from the frameClosely observe the note introducing each sub-section for this important informationIf'
AT THIS POINT ATV-0109 If the technician's objective is to servicereplace left-side cover oil seals (3), front output joint
oil seal (1), rear output joint oil seal (1), andor the oil strainer (from beneath the engine transmission), the enginetransmission