2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 124Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 124

CUpper rear: One cap screw and nut with flat washer; then two left-side engine mount-toframe cap screws Top-Side Components
the AT THIS POINT information in each sub-section NOTE: The engineltransmission does not have to removed from the frame for
this procedure Removing Top-Side Components AValve Cover BCylinder Head 25By sliding the rear of the engine out first, remove
the enginetransmission from the left side of the frame NOTE: Remove the spark plug and timing inspection plug; then using
the recoil starter, rotate the crankshaft to top-dead-center of the compression stroke NOTE: Arctic Cat recommends the use