2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 140Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 140

5Remove the gear shift cam (F) 6Remove the three remammg forks noting their positions for assembling purposesIf' NOTE: Note
AT THIS POINT To service the driveshaft andor countershaft, see Servicing Center Crankcase Components sub-section NOTE: For
efficiency, if the driveshaft andor countershaft are not being serviced, it is preferable to leave them assembledThe technician
should use discretion and sound judgment NOTE: Note the alignment marks on the crank balancer driven gear and balancer drive
gear to aid in assembly AT THIS POINT To service crankshaft assembly, see Servicing Center Crankcase Components sub-section
CAUTION Do not remove the remaining output shaft assembly unless absolutely necessaryIf the shaft is removed, the shaft nut
must be replaced with new one and the shaft must be re-shimmed 12To remove the output shaft and gear, remove the nut, slide