2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 143Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 143

2Position the dial indicator contact point on the outside edge of the valve face; then zero the indicator 3If valve guide
the cylinder head on the surface plate2Install the valve into the cylinder head; then 2Using the Standard Valve Guide Reamer
(pin 0444-017), remove any burrs or tight areas from the valve guide journals position the dial indicator contact point against
the outside edge of the valve faceZero the indicator 3To install valve guide, use valve guide installer 3Push the valve from
side to side; then from top to bottom4Maximum "wobble" deflection is 0.35 mm (0.014 inMeasuring Valve Guide (Inside Diameter)
and gently drive valve guide with retaining clip into the bore from the valve spring side until the retaining clip just contacts