2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 155Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 155

PRIMARY CLUTCH ASSEMBLY (InspectingMeasuringAssembling) NOTE: Prior to inspecting and measuring components, it is recommended
the groove on the shoe for wear or damage3If any damage to the shoe or any groove wear is marks2In tum place each driven
plate on the surface plate; noted, the shoe must be replaced then using feeler gauge, measure warpage in several locations
Inspecting clutch shoe groove ATV1014 Inspecting Starter Clutch Housing 3Maximum driven plate warpage must be 0.1 mm (0.004
inMeasuring Clutch Drive Plate (Fiber) Thickness 1Using calipers, in tum measure the thickness of each drive plate in several
locations 1Inspect the starter clutch housing for bums, marks, scuffs, cracks, scratches, or uneven wear2If the housing is
damaged in any way, the housing must be replacedInspecting Primary One-Way Drive 1Insert the drive into the clutch housing