2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 172Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 172

10Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in place NOTE: Prior
Bond Sealant (pin 0636-070) to the mating surfacesPlace the right-side half onto the left-side half5From the left side, install
the seven case half mm cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding
or sticking occurs 2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From the
right side, install the four case half mm cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth