2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 175Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 175

CAUTION The clutch sleeve hub and the clutch pressure plate must be seated in the proper positionIf any of the incorrect
of installing 10Install the primary driven washers and shims onto the driveshaft and crankshaft NOTE: After placing the primary
clutch assembly onto the shaft, pull out on the pressure plate tower to ensure the pressure plate has engaged the clutch
hub properly and make sure the plates (drive and driven) are brought together tightly prior to tightening the nut securing
the clutch assembly 12Using clutch sleeve hub holder, install the nut and washerTighten to 10 kg-m (72 ft-Ib) NOTE: The washer