2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 179Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 179

10Install the drive idler gear with one spacer and one washer CC990 13Install the two alignment pms into the left crankcase
the crankshaft; then install the magneto rotor nut on the crankshaft and tighten until the rotor is properly seatedTighten
to 16 kg-m (116 ft-lb) Cover Speedometer Drive HiLovv Shifter Assembly Recoil Starter NOTE: Steps 1-13 in the preceding sub-section
must precede this procedure 14Place the gasket and left-side cover into position on the crankcase NOTE: It may be necessary