2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 189Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 189

11Route the two vent hoses through the slots in the frame12Place the rear output shaft into position on the rear output joint;
and the mm cap screws to 2.8 kg-m (20 ft-lb); then secure the fender extensions to the footrests with existing hardware18Place
the exhaust pipe into position inside the frame and connect to the muffler at the juncture NOTE: If the muffler was removed,
see Section 8 14On the 4x4, install the propeller shaft onto the front differential couplerTighten the hardware securely15Place
the reverse shift linkage wbushing and washer onto the engine reverse shift shaft and secure with the E-dip 19Place the exhaust