2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 200Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 200

3Lay the engineltransmission on its right sideRemove the 14 left-side cover-to-crankcase mounting cap screws noting the location
for the two alignment pins and the position of the shifter bracket for installing purposes & NOTE: Inspect the inside of
the left-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective
shafts and that the starter idler gear spacer is on the shaft or in the cover CAUTION Care must be taken that the remover
is fully threaded onto the rotorflywheel or damage may occur 7Using Magneto Rotor Remover (pin 0444-075), break the rotorlflywheel