2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 222Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 222

Cleaning and Inspecting NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
handle and pull the rope out of the handle; then untie the knot in the rope and remove the handle NOTE: Do not remove the
spiral spring unless replacement is necessaryIt should be visually inspected in place to save timeIf replacement is necessary,
follow steps 9-10 9Remove the spiral spring from the case by lifting the spring end up and outHold the remainder of the spring
with thumbs and alternately release each thumb to allow the spring to gradually release from the case10Unwind the rope from
the reel and remove the rope 2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope counterclockwise
around the reel leaving approximately 50 cm (20 in ofrope free of the reel3Apply low-temperature grease to the spring and
hub4Thread the end of the rope through the guide hole of the case; then thread the rope through the handle and secure it
with double knotInstall the protective cover into the handle5Align the inner hook of the spiral spring with the notch in