2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 224Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 224

Servicing Right-Side Components NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
and bevel gear must be removed for this procedureAlso, always start with the original shims on the rear shaft scuffs, cracks,
scratches, or uneven wear2If the housing is damaged in any way, the housing must be replaced 1Place the left-side crankcase
cover onto the left-side crankcase half to prevent runout of the secondary transmission output shaft2Install the secondary
driven output shaft assembly INSPECTING PRIMARY ONE-WAY DRIVE 1Insert the drive into the clutch housing2Rotate the inner
race by hand and verify the inner onto the crankcase3Mount the indicator tip of the dial indicator on the secondary driven
bevel gear4While rocking the driven bevel gear back and race rotates only one direction3If the inner race is locked in place
or rotates both directions, the drive assembly must be replaced forth, note the maximum backlash reading on the gauge5Acceptable