2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 228Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 228

5Place the reverse driven gear dog onto the countershaft; then secure with the circlip NOTE: The countershaft is now completely
position of the alignment marks for assembling purposes; then remove driven gearwith driven gear #2Account for pins and springs3Remove
driven gear #2 from gear1; then account for large washer and keyInspecting 1Inspect the gear, pins, and keyway for wear2Inspect
the springs for damage or fatigueAssembling 1Place driven gear #2 into driven gear1; then align the alignment marks of driven
gearand driven gear #22Using pair of needle-nose pliers, insert each spring part way into the slot; then install pin and
push the springpin assembly into the slot3Place the key and the large washer into position on the balancer shaft4Place the