2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 231Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 231

CC871 MD1336 2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From the right
mm cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-Ib) NOTE: Rotate the shafts back and forth to ensure no binding or sticking occursIf'
AT THIS POINT After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side
Components, and to Installing Top-Side Components Installing Right-Side Components 4From the left side, install the remaining
crankcase cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs while tightening the cap screws AOil StrainerOil Pump 1Place the oil strainer and new O-ring into position beneath