2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 232Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 232

4Place the pin into position on the oil pump shaft, install the oil pump driven gear making sure the recessed side of the
the O-ring is properly installed and secure with the four cap screws; then tighten the oil drain plug to 2.2 kg-m (16 ft-Ib)MD1020
MD1208 MD1019 3Place two alignment pins and the oil pump into position on the crankcase and secure with the Phillips-head
screws coated with blue Loctite #243Tighten to kg-m (7 ft-Ib) 5Install the cam chain NOTE: Keep tension on the cam chain