2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 235Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 235

20Install two alignment pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover
the threads of the nut with red Loctite #271 and secure the movable drive faceTighten the nut to 10.4-11.8 kg-m (75-85 ft-Ib)
Installing Left-Side Components AStarter Idler Gears BRotorFlyvvheel 1Place the crankshaft bearing retainer into positionApply
red Loctite #271 to the three Phillips-head screwsInstall and tighten the three Phillips-head screws securely NOTE: At this
point, the wedge can be removed from between the driven clutch faces 2Install the starter motor and tighten the two cap screws