2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 239Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 239

5While keeping tension on the cam chain, place the front cam chain guide into the cylinder CAUTION Care should be taken that
the chain cavity 8Install the two lower nuts securing the cylinder head to the cylinder, one in front and one in rear CAUTION
to avoid Keep tension on the cam chain damaging the crankcase boss 9In crisscross pattern, tighten the four cylinder head
cap screws to 3.8 kg-m (27.5 ft-Ib)Tighten the two lower cylinder head nuts to 2.5 kg-m (18 ft-Ib) and the cylinder-to-crankcase
nuts to 1.1 kg-m (8 ft-Ib)10With the timing inspection plug removed and the cam chain held tight, rotate the crankshaft until
the piston is at top-dead-center11With the alignment pin installed in the camshaft, loosely place the cam sprocket (with