2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 246Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 246

35Add proper amount of enginetransmission oil36Install the seat 2Remove the negative cable from the battery; then remove
the two screws securing the fuse block; then carefully remove all the wiring from the block CAUTION It is critical that all
wiring be marked when removing from the fuse blockThis will aid in installing correctly 4Carefully guide the battery cables
and fuse block wiring down through the access hole into the engine compartment for future removing5Drain the oil enginetransmissionfrom
beneath the Oil Drain Plug Removing Enginel Transmission Many service procedures can be performed without removing the engineltransmission
from the frameClosely observe the note introducing each sub-section for this important informationIf' 733-441 A AT THIS POINT
If the technician's objective is to servicereplace left-side cover oil seals (3), front output joint oil seal (1), rear output
joint oil seal (1), andor the oil strainer (from beneath the engine transmission), the enginetransmission does not have to