2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 250Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 250

Top-Side Components NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to
plug and timing inspection plug; then using the recoil starter, rotate the crankshaft to top-dead-center of the compression
stroke 37Remove the torx-head screws securing the left-side clutch plenum to the engine; then remove the plenum and account
for gasket 1Remove the two tappet covers 38Remove the engine from the right side by moving the engine forward while raising
the engine in the rear and rotating the engine counterclockwiseThe engine will come out the right side of the frame NOTE:
Keep the mounting hardware with the covers for assembly purposes or thread them back into the head to keep them separated
2Remove the 12 cap screws securing the valve cover to the head; account for the four rubber washers on the top side cap screwsRemove