2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 256Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 256

8Using Side Case Puller (pin 0644-262), remove the side coverAccount for gasket and two alignment pins NOTE: Inspect the
gears for installing purposes; then remove the two starter gear shafts 9Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller adapter NOTE: The puller has left-hand threads 10Using Magneto Rotor Remover
Set (pin 0444-075), remove the rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter clutch
gear assembly and washerCC637 12Remove the snap ring securing the water pump driven gear; then remove the gear noting the