2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 289Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 289

19Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-Iengthed
side of the intermediate gear facing inward as noted in removing) 1Install the water pump drive gear alignment pin and the
drive gear (with the flat side of the gear facing outward as noted in removing); then secure with the snap ringCC636 4In
order on the crankshaft, install washer, ring gear, key, and the magneto rotorSecure with the nut (threads coated with red
Loctite #271)Tighten to 16 kg-m (116 ft-Ib)5Lubricate the magneto cover gasket with fresh engine oil; then place it into
position on the two dowel pins NOTE: The sharp side of the snap ring should be facing outwardInstall the water pump driven