2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 291Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 291

Installing Top-Side Components APiston BCylinder 12345678Cylinder Stud Bolt Nut Cylinder Gasket Pin Water Hose Union Cap
the end gaps of the upper and lower thin oil rings according to the illustrationFront #1 Compression Ring End Gap #3 Thin
Oil Ring End Gap #3 Thin Oil Ring End Gap #2 Compression Ring End Gap and 011 Ring Expander End Gap ATV-1085B 2Place the
two alignment pins into positionPlace the cylinder gasket into position; then place piston holder (or suitable substitute)
beneath the piston skirt and square the piston in respect to the crankcase NOTE: Note the direction of the exhaust side of
the piston (5) for correct ring end gap orientation BInstall the compression rings (1 and 2) so the letter on the top surface