2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 321Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 321

2Remove the reverse shift cam (G) and spacer3Disengage four forks from the gear shift cam (F); then remove the reverse shifter
driven gear is not being serviced, it is preferable to leave it assembledThe technician should use discretion and sound judgment
6Remove the reverse idle gear (K) wlshaftAccount for the bushing, two washers, and the circlip7Simultaneously, remove the
driveshaft assembly (I) and countershaft assembly (D)Account for the washer on the counters haftIf' 10Remove the crank balancer
assembly (A) NOTE: When removing the crank balancer assembly, rotate the crankshaft counterweight away from the crank balancer
assembly counterweight AT THIS POINT To service the driveshaft andor countershaft, see Servicing Center Crankcase Components
sub-section NOTE: For efficiency, if the driveshaft andor countershaft are not being serviced, it is preferable to leave