2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 338Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 338

5Place the primary gear assembly on clean, flat surface; then install the primary washer into the assembly CC922 3Install
being careful not to disturb the drive plate notched tab orientation CAUTION The clutch hub and the pressure plate must be
seated in the proper positionIf any of the incorrect positions are used, the hub and plate will have clearance between them
and they will not operate properly NOTE: The primary clutch assembly is now completely assembled for installation INSPECTING
OIL PUMP 1Inspect the pump for damage2It is inadvisable to remove the screw securing the pump halvesIf the oil pump is damaged,