2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 353Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 353

10Install the two gear shift shafts; then verify that the two crankcase half alignment pins are in place 2Using plastic mallet,
case); then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs Joining
Crankcase Halves 1Place the O-ring in the left -side crankcase half and verify that the washer is on the idler shaft; then
apply Three Bond Sealant (pin 0636-070) to the mating surfacesPlace the right -side half onto the left -side half 4From the